Table des Matières
Publicité
The meter is a completely portable LCD 3½ digital clamp meter. It has rugged design, is easy to hold in
operator's hand and convenient to use.
1. Safety Information
1.1 Read the following safety information carefully before attempting to operate or service the meter.
1.2 To avoid damages to the instrument do not exceed the maximum limits of the input values show in the
technical specifications tables.
1.3 Never measure current while the test leads are inserted into the input jacks.
1.4 Do not use the meter or test leads if they look damaged. Use extreme caution when working around
bare conductors or bus bars.
1.5 Caution when working with voltages above 60VDC or 30VAC RMS. Such voltages pose a shock
hazard.
1.6 Note: When the display shows "1" , the input value is higher than the range. For example, If the
display shows "1" in 200V range, the voltage is higher than 200V at the input of multimeter.
2. Operating Features
Ranges
DC Voltage:
AC Voltage:
AC Current:
Resistance:
Measurement category: CAT II (not suitable for measuring in measurement category CAT III and CAT IV)
The meter display is a liquid crystal assembly providing a readable display in all light conditions.
The decimal point is automatically positioned, and the polarity sign (minus) is lighted for negative DC
measurement (plus is understood if no sign appears), so that the display is direct reading in units selected
at the rotary switch. Overrange measurements are indicated by the symbol "1". The display includes a low
battery indication. If low battery is indicated, operator should replace the used battery with new one.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Digital Clamp–on Multimeter
200 V – 600 V
200 V – 600 V
2000 mA – 20 A – 600 A
200 Ohm – 200 KOhm
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 2203
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicité
Table des Matières
