Standards Of Reference; Declaration Of Conformity - Fiem CIP CIP 28 Manuel D'utilisation

WARRANTY
Each part of the machine has been fully tested by the manufacturer before delivery or shipping. The manufacturer's
guarantee does not include damage caused by improper transport and does not include damage to the electrical and
electronic systems caused by incorrect connection to the power supply.
The guarantee includes repairs or replacement of all the parts that are found to be defective in the 24 months (12
months by the manufacturer + 12 months by the seller) following the delivery of the machine to the customer and
applies when the customer informs the manufacturer, no later than the eighth day from when the fault occurred. This
Guarantee refers to possible defects in workmanship and it is excluded in any case of improper use, improper place-
ment and connection or in any case of tampering from unauthorized personnel. The guarantee includes all technical
telephone support, but the customer is liable for all shipping costs for sending all defective parts to be replaced to
FIEM and all technical call-out costs.
The guarantee does not include any compensation for any downtime of the machine or damages incurred
during use.
Only staff authorised by the manufacture must be allowed to carry out repairs under the guarantee; if this
clause is not adhered to, the guarantee will cease to apply.

STANDARDS OF REFERENCE

This product conforms to the essential Electromagnetic and safety requirements foreseen by the following directives:
• 2004/108/CE del 15/12/2004
• 2006/95/CE del 12/12/2006
as projected in conformity to the prescriptions of the following Harmonized Rules:
• EN 55014-1: 2006
• EN 55014-2: 1997+A1:2001
• EN 61000-3-2: 2006
• EN 61000-3-3: 1995+A1:2001+A2: 2005
• EN 60335-2-71: 2003+A1:2007
Conformity to the above requirements is attested by
The mark was introduced in 1995.
It is opportune to underline the following actions that can predjudge the conformity and moreover
the product characteristics:
• incorrect electricity supply;
• incorrect installation or incorrect /improper use or not conforming to the instructions reported in the instruction
book supplied with machine;
• replacement of its components with those not approved or adopted by the manufacturer, or replacement effected
by unauthorized technical service.
WARNING: THIS EQUIPMENT MUST BE EARTHED.
ATTENZIONE: QUESTA UNITÀ DEVE ESSERE CONNESSA A TERRA.
ATTENTION: CETTE UNITE DOIT ETRE MISE A LA TERRE.
ACHTUNG: DIESES GERAT MUSS EINEN ERDUNGSANSCHLUSS HABEN.
ATENCION: ESTE EQUIPO DEBE ESTAR CONECTADO A UNA TOMA DE TIERRA.
APPARATET MA KUN TILKOPLES JORDET STIKKONTACT. APPARATEN SKALL ANSLUTAS TILL JORDAT NATUKKAT.
LAITE ON LITTETTAVA SUKO-RASIAAN.
Manufactured in the EU for:
THE MACHINE
MODEL
SERIAL NUMBER
IS MANUFACTURED AND SOLD IN CONFORMITY TO THE ESSENTIAL REQUIREMENTS OF HEALTH AND SAFETY
of D.M. 17 of 17 January 2010 – Attachement I (implementation of the Machinery Directive 2006/42/EC)
16

DECLARATION OF CONFORMITY

of the attachement II, part. 1 section A of DL/17/2010/CE
Incubatrici F.I.E.M. S.r.l.
Via Galileo Galilei, 3 - 22070 Guanzate (Como) - Italia
DECLARES THAT
Incubator
CIP CIP 28
marking on the product;
CIP CIP 40