ALPATEC Ligne BH2 Mode D'emploi page 7

All manuals and user guides at all-guides.com
BH2_notice:RBH_notice 3/05/11
• Plug the appliance
POWER SETTING :
• Turn the power mode selector (2) clockwise to choose the mode setting.
Position I: low power heating
Position II: middle power heating
Position III: high power heating
• The operating light indicator lights on when the appliance is in use.
• To switch off the appliance, turn the power mode selector on O position.
TEMPERATURE SETTING :
• Set the thermostat to maximum position. The light indicator comes on.
• When the room is at the required temperature, slowly turn the thermostat anticlock-
wise until to break point. The appliance will now switch on and off automatically to
keep the room at the desired temperature.
• This function will maintain room temperature and also save energy.
ANTI FROZEN FUNCTION :
- For anti frozen function, set power I, II or III and turn the thermostat to min to put in front of the visual mark.
When room temperature goes down 4°C, the appliance will automatically starts in order to keep this
temperature.
AUTOMATIC CUT-OFF :
• This appliance is equipped with an automatic cut-off device in case of overheating.
• Switch off and unplug the appliance.
• Clean the body with a soft, dry cloth (never immerse appliance in water), do not allow water to run into the
interior of the heater.
• Never use abrasives or detergents.
• The dust may be removed with a soft cloth or a vacuum cleaner.
• When the heater is not used for a long time, protect it from dust and dry.
17:47 Page 7
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
CLEANING
CLEANING
7