Measuring Surface Areas; Addition Of Surface Areas - Powerfix Profi Z32114 Instructions D'utilisation Et Consignes De Sécurité

All manuals and user guides at all-guides.com
4. Press the + / = button again. The new meas-
urement is added to the old in the lower row.
5. Repeat steps 3 to 4 to add further measure-
ments.
6. Press the MODE button
addition mode. All the measurements will be
deleted.

Measuring surface areas

1. Slide the function switch
„DISTANCE". The display
2. Press the MODE button
„L" (length) appears in the display.
3. Press the READ button
length. The measured length appears in the
upper row of the display and the message
„W" (width) starts to blink.
4. Press the READ button to measure the width.
The measured width appears in the upper
row of the display. The results of the surface
area calculation appear in the lower row.

Addition of surface areas

1. Measure an area as described in the section
„Measuring surface areas".
2. Press the M button
appears in the display
surface area is saved.
to leave the
4
to the position
9
is turned on.
2
once. The message
4
to measure the
6
. The message „M+"
7
. The measured
2
GB/IE 19