Important Safeguards - Andis SMC-2 Mode D'emploi

E N G L I S H
Please read the following instructions before using your new Andis
clipper. Give it the care that a fine precision built instrument deserves
and it will give you years of service.

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should
always be followed, including the following: Read all
instructions before using the Andis clipper.
DANGER:
To reduce the risk of electric shock:
1. Do not reach for an appliance that has fallen into water.
Unplug immediately.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can fall or be
pulled into a tub or sink. Do not place in or drop into
water or other liquid.
4. Always unplug this appliance from the electrical outlet
immediately after using.
5. Unplug this appliance before cleaning, removing or
assembling parts.
WARNING:
To reduce the risk of burns, fire
electric shock, or injury to persons:
1. An appliance should never be left unattended when
plugged in.
2. Close supervision is necessary when this appliance is used
by, on or near children or individuals with certain disabilities.
3. Use this appliance only for its intended use as described
in this manual. Do not use attachments not recommended
by Andis.
4. Never operate this appliance if it has a damaged cord or
plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water. Return the appliance
to an Andis Authorized Service Station for examination
and repair.
2
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is being
administered.
8. Do not use this appliance with a damaged or broken
blade or comb, as injury to the skin may occur.
9. To disconnect turn control to OFF then remove plug from
outlet.
10. WARNING: During use, do not place or leave appliance
where it may be (1) damaged by an animal or (2) exposed
to the weather.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
IMPORTANT INFORMATION
Your new clipper contains a microchip – please note the following:
• When the unit is plugged in, you may experience slight movement in the
blade. This is normal as the microchip powers up.
• If you unplug your clipper, please wait 30 seconds before plugging it back
in to allow the microchip to be reset.
OPERATING INSTRUCTIONS
Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current
or as noted on the unit.
2-SPEED OPERATION
Your Andis clipper is equipped with two cutting speeds. The speeds are
adjusted using the slide switch actuator on the side of the unit (Figure A).
The settings are 0-1-2. After using your Andis clipper, rewrap cord and store
in a safe place.
3