Wiring Diagram For The Coaxial Antenna; Installation - LEGRAND 035 82 Notice D'installation

All manuals and user guides at all-guides.com
1 - Introduction

1.6 - Wiring diagram for the coaxial antenna

NOTE: In order to receive the radio channels correctly the type of antenna used must be selected:
if the 035 82 is installed in an area of the building with sufficient signal, the wire antenna can
be used. If the signal inside the building is not sufficient, the external antenna can be used (e.g.
antenna installed on the roof ), with the coaxial connector and the appropriate adapter cable. The
type of antenna is selected using the configurator.
System for cable distribution of television signals with connection to the FM antenna through
A
dedicated connection, or FM antenna system only, in accordance with CEI-EN-50083.
Maximum level 70 dBµV
B
Minimum level 40 dBµV (mono) - 50 dBµV (stereo)
(ref. standard IEC-EN-50083-7)
Maximum and minimum levels to be guaranteed at the antenna socket for correct
reception of the FM band.
Failure to observe the signal levels described in point B may affect the reception properties
of the audio signal and the RDS signal.

1.7 - Installation

1 Make sure that the Tuner is disconnected from the BUS.
2 Configure the device.
3 Install the device on the DIN rail in a position where positioning of the wire antenna is easy
4 In order to use the coaxial antenna, connect the type F connector of the adapter cord to exter-
nal receiving devices (local antennas or antenna systems) and the MCX connector to the ANT
terminal as shown in the connection diagram.
5 Connect the Tuner to the BUS as described in the "Connection to the scs bus and configuration"
section.
6 Switch ON the BUS.
F
A B
MCX
17