Orbegozo FH 5009 Manuel D'instructions page 11

FH 5009
These instructions for use belong to the appliance and
must be kept in a safe place. When changing owners,
these instructions must be surrendered to the new
owner!
SAFE POSITIONING
• The heater must not be located immediately below a socket outlet.
• Only use the fan heater when it is standing in a horizontal position. Do not place the heater on instable
surfaces, such as bed, carpets etc. and do not use the heater on uneven position, where the heater can tip
over – otherwise there is a risk of fire.
• The heater should be placed with a minimum distance from flammable objects, walls, structure etc. A safe
area to be left free is 100 cm at the front and at the sides and 100 cm at the top. The appliance opening
must not be obstructed in any way.
• For your own safety and that of others: water and electricity are a dangerous combination! Do not use this
heater in a bathroom or near a swimming pool. Ensure that the appliance cannot fall into water (bath wash
basin, shower cubicle, etc.)
• Please read also the safety information before using.
• Do not use the heater on extremely deep-pile carpets!
INSTALLATION
The appliance requires no installation; it should be used solely as a portable appliance. Portable appliances
are not suitable for use in a bathroom.
OPERATION
Turn the thermostat (right) in a clockwise direction until it reaches the maximum setting.
MODEL FH 5009:
- Only ventilation: turn the knob to setting
- Heating at reduced power: turn the knob to setting
- Heating at full power: turn the knob to setting
- Switch off: turn the knob (left) to setting modo .
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power
as soon as the heating elements become too hot. If this should happen:
First ensure that it was not the thermostat which has switched off the heater. Set the thermostat to
maximum position. If the heater does not switch on, the safety device has been activated.
- Remove the mains plug from the wall socket.
- Let the heater cool down for 30 minutes.
- Check if the heater had been placed correctly.
- Check if anything is obstructing the air flow.
- If necessary, clean the grilles with a vacuum cleaner.
(1000 W)
(2000 W)
11