Safety Instructions; General Safety Rules - Hilti PSA 81 Mode D'emploi

Rated voltage
IP protection class
Operating temperature range
Storage temperature range (dry)
Charging temperature
Weight
Dimensions (L x W x H)
PUA 82 AC motor vehicle adapter (for PSA 81 and PRA 84 batteries, PSA 100 monitor)
Input voltage
Rated power
Rated voltage
IP protection class
Operating temperature range
Storage temperature range (dry)
Charging temperature
Weight
Dimensions (L x W x H)

5. Safety instructions

In addition to the information relevant to safety
given in each of the sections of these operating
instructions, the following points must be strictly
observed at all times.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.

5.1 General safety rules

a) Do not render safety devices ineffective and do
not remove information and warning notices.
b) Do not use force when inserting a battery in a
tool or appliance.
c) Store appliances in a secure place when not in
use.When not in use, appliances must be stored
in a dry, high place or locked away out of reach
of children.
d) Follow the instructions concerning care and
maintenance.
e) Use the supply cord only for connecting to the
mains supply.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070487 / 000 / 00
All manuals and user guides at all-guides.com
8.4 V
IP 56
-20...+40°C
-25...+85°C
+0...+45°C
0.54 kg
143 x 143 x 48 mm
11...36 V
36 W
12 V
IP 54
+0...+40°C
-20...+85°C
+0...+40°C
0.24 kg
105 x 40 x 26.5 mm
f) Check to ensure that the appliance and supply
cord do not present an obstacle that could lead
to a risk of tripping and personal injury.
g) Check extension cords at regular intervals and
replace them if damage is found. Do not touch
the mains adapter if the extension cord or mains
adapter are damaged while working. Disconnect
the supply cord plug from the power outlet.
Damaged supply cords present a risk of electric
shock.
h) Do not expose the supply cord to heat, oil or
sharp edges.
i) Never operate the mains adapter when it is dirty
or wet. Dust (especially dust from conductive
materials) or dampness adhering to the surface
of the mains adapter may, under unfavorable
conditions, lead to electric shock. Dirty or dusty
appliances should thus be checked at a Hilti
service center at regular intervals, especially
if used frequently for working on conductive
materials.
j) Avoid touching the contacts.
en
19