ALPATEC DH 20 E Mode D'emploi page 10

All manuals and user guides at all-guides.com
notice DH 20 E impo 26/04/07
WHAT TO DO WHEN THE WATER TANK IS FULL
When the WATER FULL indicator is switch on the dehumidifier will stop working. Pull the bucket out by
placing your hands on each side and pull it towards you. When you have emptied the tank place it in the
appliance. It is now ready to carry on dehumidifying.
INSTRUCTIONS FOR CONTINUOUS DRAINAGE
YOU MUST SWITCH OFF AND UNPLUG THE APPLIANCE OUT OF THE SOCKET.
FOR A GOOD DRAINING OF WATER FOLLOW THE INSTRUCTIONS BELOW :
1. Remove the plastic cover.
2. Push the hose into the drain hole (a PVC hose).
3. Remove the water tank, then push the hose onto the connector located inside
of the hole. And reinsert the water tank.
4. The other part of the hose must be placed in a container.
Caution : When adopting continuous drainage method, the drainage hose must be on level ground.
INSTALL THE FILTER
DEFROST
When operating in low temperatures (less than 12°C) the surface of the evaporator will accumulate frost
and affect the performance efficiency of the dehumidifier. When this happens the appliance will go into
periodic defrost mode automatically. When defrost time is finished the appliance will run normally. The
appliance can operate above 5 °C.température supérieure à 5 °C.
15:19 Page 10
Caution : Always switch oo the appliance.
Switch off the appliance, open the air inlet from the
notch above as shown.
It is recommended to check and clean the air filter
every 2 weeks.
10