Troubleshooting; Alarm Codes - Polar Refrigeration W518 Mode D'emploi

UK

Troubleshooting

Fault
The appliance is
not working
Appliance is noisy
or works
intermittently
Wine cooler cabinet
is not cold enough
The light does not
work
Doors will not close
properly

Alarm Codes

Alarm Code
Cooling sensor fault
E1
E2 Defrost sensor fault
Cabinet temperature lower
LL
than -1°C
5
All manuals and user guides at all-guides.com
Probable Cause
The appliance is not
switched on
Plug and lead are
damaged
Fuse in the plug has
blown
Power supply
Internal wiring fault
Power fluctuations
Appliance is not level
Temperature set
incorrectly
External environment
may require colder
temperature
The door is opened
too often
Door seal is worn
Bulb has blown
Light switch set to Off Set light switch to On
Wine cooler is not
level
Door has been
reversed and not
properly fitted
Shelves are out of
position
Door seal is dirty
Probable Cause
Check the appliance is plugged in correctly and switched on
Call POLAR agent or qualified technician
Replace the plug fuse
Check power supply
Call POLAR agent or qualified technician
Turn off the wine cooler and restart after 3 minutes
Adjust the feet to level the appliance
Check temperature and reset if necessary
Check temperature and reset if necessary
Only open when necessary
Call POLAR agent or qualified technician
Replace bulb (see "Replacing the Bulb" on page 4)
Adjust the feet
See "Reversing the Door" on page 2
Check all shelves are properly inserted
Wipe clean with a damp cloth
Call POLAR agent or qualified technician
Call POLAR agent or qualified technician
Raise operating temperature
If alarm persists then call POLAR agent or qualified
technician
Action
Action