Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite LED Fleming Wall Sconce & Vanity Light
®
General Wiring Diagram
CAUTION: Turn off electrical power at fuse
or circuit breaker box before wiring fixture to
the power supply.
Connecting panels to AC source supply:
All units must be individually connected to
the AC supply. (120 VAC)
Black = Line
White = Neutral
Green = Ground
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1.
For CCT selectable models, locate the etching on
the backplate indicating the CCT switch side of the
select the desired CCT (Fig. 1)
fixture. Remove the cover to access the switch and
2.
(Fig. 2)
Install the mounting plate onto the junction box.
3.
Connect the wires per the general wiring diagram
with wire connections provided. The black wire is
the copper wire is ground. (Fig. 3)
the live wire, the white wire is the neutral line and
4.
Secure the fixture to the mounting plate with screws.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
1
2
junction box
3
ground wire screw
wall
ground wire
ground wire
wire
wires
snap
Fleming Series
Set the CCT switch
to the desired position
mounting plate
fixture
Page: 2
REV: 7/02/21
Publicité
