Adler europe AD 7044 Mode D'emploi page 5

19. Do not aim the vacuum cleaner toward other people or animals.
20. The vacuum cleaner may be used only on dry surfaces.
21. Only use accessories designed for this appliance.
22. Use extra care when vacuuming stairs.
23. Do not block any vents.
24. Do not operate the vacuum cleaner without the filter.
25. Do not pull the vacuum cleaner by the hose.
26. Make sure that the power cord is not wedged by a door and does not get jammed.
When moving the vacuum cleaner please note the length of the power cord. Pulling the
vacuum cleaner suddenly when the cord is taut may damage it.
27.Vacuuming dust and residues of construction causes immediate loss of warranty. The
vacuum cleaner is designed for domestic use only.
28. The device is outfitted with a rechargeable battery. Do not throw into a fire, puncture,
crush or damage the battery.
Device Description: (Handheld vacuum cleaner)
1.Battery status 2. Dust Cup Release Button 3. Dust Cup 4. Wand Release Button 5.TUBE 6. Nozzle Release Button
7.Motorized Nozzle 8. Turbo Button 9. ON/OFF Button 10. Battery Pack Release Button 11. Battery Pack
12.Dust Cup empty Button 13. 2 in 1 Upholstery Brush 14. Long Crevice Tool 15. Charging Adaptor 16. Wall mount
·BATTERIE UNIT
Insert the batteries unit into the bottom of the machine and when it locked into the machine, you will hear the sound of connection. Pay
attention to the direction. (FIG.1)
·DUST CUP ASSEMBLY ASSEMBLED WITH THE MAIN PART
Firstly insert the lower plastic chip into the hole of the main part, then lock the upper cover with the upper lock of the main part. (FIG.2)
CONNECTION OF BRUSH
Insert the upper part into the lower connection of the power tube and can hear the sound of locking. (FIG.3)
CONNECTION WITH TUBE
Insert the upper ends into the main hole of the dust cup and can hear the locking sound (fig4)
Connection of power brush and main machine
Insert the upper part of the power brush into the main hole of the main machine (fig.5)
·Connection of accessory brushes with main machine
Insert the accessory brushes into the main hole of the main vacuum cleaners(FIG. 6,7)
·LOW SPEED, HIGH SPEED, OFF
To turn the device On/OFF press the On/OFF button (9)
Use the TURBO button (8) to shift the speed from low to high.
·Vacuum cleaner charging
Please use the designated adaptor to charge the vacuum cleaner
Plug the adaptor and when charge the light will glow in red when it is full, the light will turn blue
You can recharge the batteries unit alone or within the machine
Clean after each use
Press the upper button (2) to release the dust cup assembly unit (3), then press the lower button to release the dust cup lower cover. It
is recommended to clean the dust cup after using it every time.
Dust cup cleaning
a) Press the button to release the lower cover of the dust cup to empty the dust (FIG.9,10)
b) Take out the filter as fig.14 show and clean or change it. (FIG.11)
c) Clean the filter under running water and dry it under sunlight
5