Urmet 1051/035 Notice D'installation page 4

ENGLISH
The remote control 1051/035 with control feedback on indicator LEDs (version 2) is used to arm (totally or partially) and to
disarm the system; it can also be used to send a panic alarm.
Part identification
1. BUTTON
Press this button to arm the system totally.
2. BUTTON
Hold this button pressed for 3 second to send a panic alarm
regardless of system state.
<Note>
Once activated, the panic alarm cannot be blocked by pressing
the off button. To block the alarm, it is necessary to send a
deactivation control either from the app or from the keypad or
from a second remote control. The alarm will be interrupted whenever the set timeout is reached.
3. BUTTON
Press this button to arm the system partially.
4. BUTTON
Press this button to disarm the system.
5. TWO-COLOUR LED INDICATION
The LED can provide the following information to the user when the remote control buttons are pressed:
•
the arm/disarm control was run by the control unit: the red LED will blink and then turn briefly green to indicate
correct implementation
•
the arm/disarm control was NOT run by the control unit: the LED flashes red rapidly 8 times. This may be the case
in which the system displays a fault upon arming, such as an open access door contact. In this case, the user can
choose to arm the system all the same by pressing the arm button again
•
a panic alarm was activated: the red LED will blink quickly 6 times without further indications
•
the remote control is out of range of the control unit: the red LED will blinked three times
6. BATTERY HOUSING
The remote control is powered by a CR2032 3 V lithium battery. The flat battery signal sent to the control unit during normal
signal transmission and the control unit will display the respective state.
<Note>

When replacing the battery, after having removed the flat battery, press any button twice to discharge the
device completely before inserting the new battery.

If a flat battery is inserted, the LED will blink three times to indicate it.
Preparation
•
Remove the cover from the battery.
•
Insert the battery with the side without marking (negative) facing downwards. Close the cover.
•
Start the learning function on the control unit; see the control unit manual for more information.
•
Press any button on the remote control.
•
The respective information will be displayed if the control unit receives the remote control signal correctly.
•
Refer to the manual of the control unit to complete the learning process.
Technical specifications
•
Power supply: 1 lithium battery CR2032 3V
•
Battery life: 3 years (typical value, may vary according to use)
•
Two-way radio frequency: 868 MHz
•
Working temperature range -10°C to +45°C
•
Dimensions: 50 X 33 X 14.5 mm
•
Weight: 60g
•
Certification EN 50131 Degree 2, Class Ⅱ
Hereby, URMET S.p.A. declares that the radio equipment type: 4-BUTTON REMOTE CONTROL 1051/035 is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.urmet.com.
4
SIMPLIFIED EU DECLARATION OF CONFORMITY
DS1051-003C