ELAC AirX2 Mode D'emploi page 5

Connecting the transmitter for Subwoofer Use
• If you are connecting the transmitter to an AV
receiver or pre-Amp with a dedicated subwoofer
or LFE output, connect a RCA cable (not supplied)
from the LFE/Subwoofer output on the AV
Receiver/Pre-Amp to the Right RCA input on the
subwoofer (Fig 1).
• If you are connecting the subwoofer to a pre-amp
or receiver without a dedicated LFE/Subwoofer
output, connect a set of stereo RCA connectors
from pre-outs on the pre-amp to the left and right
RCA inputs on the subwoofer (Fig 2). If you are
using a pre-amp with only one set of pre-outs,
use a splitter for each output on the pre-amp and
connect two sets of stereo RCA cables to both the
amplifier and to the subwoofer.
Connecting the transmitter with ELAC Navis Speakers
• When using the AirX transmitter with ELAC's Navis
wireless speakers connect the variable audio
outputs from you pre-amp/source as shown in
Fig 1. (PLEASE NOTE THAT THE TRANSMITTER
DOES NOT CONTROL VOLUME! A FIXED LEVEL
SOURCE WILL OUTPUT AT FULL VOLUME!)
• Please follow the pairing process on page 7 to
wirelessly connect the Navis speakers to the
transmitter.
Pre-Amp/Source with
Variable Audio Output
ELAC AirX Transmitter | www.elac.com | Page 4
Fig 1
AV RECEIV ER
SUB
Fig 2
Pre-Amp/Receiver
PRE
PRE