Weidmüller KT 55 Mode D'emploi page 3

en
English
For copper and aluminium cables
Not suitable for cutting steel-armoured cables,
aluminium alloys and hard drawn copper conductors
• Release hand lever
points to the ON dot on the cover plate.
• To turn the pivoted blade
required:
When using the with 45-mm or 55-mm Ø cable cutter, hold
handle
It is now possible to turn the pivoted blade
When using the 80 mm Ø cable cutter, set the locking pin
to the OPEN position, hold the handle
the pivoted blade
To cut cables, re-set the locking pin to the position CUT.
• Insert the cable and turn the pivoted blade
the blade rests on the cable.
When using the 80 mm Ø cable cutter, re-set the locking pin
to the position CUT.
• Squeeze the handles to manually operate the pivoted blade
until the inserted cable is cut through.
• It is possible to unlock the pivoted blade
process.
To do so, proceed as follows:
When using the with 45-mm or 55-mm Ø cable cutter:
Squeeze handles
pawl can easily be disengaged. Keeping the retaining pawl
pressed down, release handle
pivoted blade
When using the 80-mm Ø cable cutter:
Set the locking pin
(squeezing together both halves) until the retaining pawl
engages automatically. Hold the handle
back the pivoted blade
The tool is designed for use in applications described in
the operating instructions only. Using this tool for tasks other
than those described may lead to accidents or the destruction of
the tool.
Subject to the frequency of use and type of service, the tool
must be checked regularly to ensure flawless functioning. In the
event that appropriate tests are not possible on site, these can
be conducted by the manufacturer.
The tool must only be repaired by an electro-mechanical
specialist or by the manufacturer, otherwise operator accidents
may result.
by turning locking knob
fully open and press down the retaining pawl
.
(both halves) together until the retaining
.
to OPEN and squeeze the handle(s)
E
in any direction to the position
and turn back the
.
5
, until the dot
as required.
fully open and turn
until the edge of
during the cutting
fully open and turn
.
E