Dynex DX-NBKIT20 Guide De L'utilisateur page 12

All manuals and user guides at all-guides.com
DX-NBKIT20-combo.fm Page 12 Friday, May 6, 2005 4:46 PM
12
5 If you use a dial-up modem, disconnect the telephone cable from the wall
and plug it into the notebook surge protector jack labeled OUT.
6 Plug one end of the supplied telephone cable into the wall telephone jack
and plug the other end into the notebook surge protector jack labeled IN.
Understanding the indicators
The Power indicator is green when power is turned on.
The Surge indicator is red when surge protection is turned on.
Troubleshooting
Problem
No dial tone
Network is
disconnected
Green power indicator
and red surge
indicator are not on.
Green power indicator
is on, but red surge
indicator is not on.
Using the notebook surge protector
In Out
Solution
• Make sure that the telephone cables are fully inserted into
the correct jacks.
• Make sure that the network cables are fully inserted into the
correct jacks.
• Make sure that the outlet has power and the power cord is
plugged in.
• Contact technical support.
• Contact technical support.