All manuals and user guides at all-guides.com
notice_EX823_reso
28/11/05
STEP 4: Press the Steam Switch
(S) ON, wait for several seconds
to let the water accumulated in
the Steam duct (D) run out for
cleaning purpose. Then press
down the Steam Switch (T) OFF
to terminate the cleaning
process.
STEP 5: Rotate Steam duct (D)
outwards closing to the right
corner. Then move the container to the Steam duct (D) and
locate this Steam duct (D) in the middle of this container, and immerse the bottom end of the duct
into the fresh milk. (Fig.4).
STEP 6: Press down the Steam Switch (S) ON to commence the frothing.
[ATTENTION: When milk foam starts to create, operator should lower down somewhat the container
to attain the favorable
frothing effects and avoid any foam likely from overflowing out of the mouth of the container]. After
achieving the expected
frothing, press down the Steam Switch (T) OFF to turn off the steam.
STEP 7: Rotate the Steam duct (D) inwards, and repeat the above procedure 4 for cleaning purpose.
STEP 8: Press Power Button (N) to disconnect the power, empty Anti drip.
STEP 1: Repeat the above procedure 1,2
STEP 2: Put a cup under the steam duct.
STEP 3: Press down the steam Switch (S) ON, and press down Brewing Button (P),the pump will
work. Then the steam will come our from the steam duct into the cup at first, then the hot water will
come from the steam duct into cup.
STEP 4: The hot water will come out until the water in water tank is out if the steam switch and the
Brewing Button are in ON position. if you want terminate the hot water, just put either the Steam
Switch or the Brewing Button in OFF position.
ATTENTION: During the operation, the temperature of steam duct and base of boiler is very high;
don't touch them with your hand.
To get optimal result, before every usage, please fit the empty funnel bracket into the unit properly,
and use only water in the first cycle ,then throw away the water in the cup.
0:55
Page 14
steam OFF
steam ON
HOW TO OPERATE TO HOT WATER
14