Installing The Receiver - ferolli CONNECT Notice D'installation Et D'utilisation

All manuals and user guides at all-guides.com
USB cable Power supply AAA type batteries
Table support Accessories

4.2 Installing the receiver

aTTEnTIOn: To protect the device, remove the power supply from the boiler before mak-
ing the connection. The operation must be carried out by qualified personnel.
The receiver can work with the OpenTherm protocol or with the On-Off contact.
Use the magnetic plate or the double-sided adhesive (supplied with the accessories) to
place the receiver in the best position according to the quality of the surface, or use the
screws to secure it directly to the wall.
33
EN
cod. 3541S181 - Rev. 00 - 09/2020