Hilti SF 10W-A22 Mode D'emploi page 16

Symbols
Revolutions Drilling
per minute without
hammering
en
Location of identification data on the power tool
The type designation can be found on the type identific-
ation plate at the base of the power tool and the serial
2 Description
2.1 Use of the product as directed
The SF 10W-A22 and SF 8M-A22 are hand-held, cordless drill / drivers designed for driving and releasing screws and
drilling in steel, wood and plastic.
Do not use the battery as a power source for other unspecified appliances.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
2.2 Standard equipment includes:
1 Power tool
1 Side handle
1 Operating instructions
1 Hook wrench (SF 8M‑A22)
NOTE
Accessories can be found at your Hilti Center or online at www.hilti.com.
2.3 Charge state and overheating indicator display on the Li-ion battery
When the lithium-ion battery is in use, the charge status can be indicated by gently pressing one of the battery release
buttons (press until resistance is felt - do not release the battery). The display on the rear of the battery provides the
following information:
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
-
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs flash, please refer to the information given in the Troubleshooting section.
2.4 Additional items required for operating the tool
A suitable battery of the specified type (see table in the Technical Data section) and a suitable battery charger from
the C 4⁄36 series.
12
All manuals and user guides at all-guides.com
number on the side of the casing. Make a note of this
data in your operating instructions and always refer to it
when making an enquiry to your Hilti representative or
service department.
Type:
Generation: 01
Serial no.:
LEDs blink
-
-
-
-
LED 1
LED 1
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
The battery has overheated