Led Indicators - SOUNDPEATS S3 Mode D'emploi

Note:
• RX / TX mode can only be successfully switched after the adapter
is turned off for 3 seconds. After the switch, the pairing history of
the devices will be cleared.
• The SPDIF and AUX mode can be freely switched.
• In SPDIF mode, connect devices through SPDIF IN for TX mode
and SPDIF OUT for RX mode.

LED Indicators

LED Indicator Status
Solid Red LED Charging
LED Off Fully charged
Flashing Red and Blue Pairing in TX / RX mode
Flashing Red Low battery
Solid Blue LED Successfully paired
How to Use
Charging
1. Connect the Micro USB end of the charging cable to the
charging port of the Bluetooth adapter.
2. Plug the USB end of the charging cable to a USB charging port
or any active USB port.
3. The LED indicator will turn red when charging. It will automatical-
ly turn off when the device is fully charged.
Note:
• You can use the adapter while it is charging.
• We recommend charging the unit for at least 2 hours before
using it for the first time.
Pairing
Pair in TX mode:
1. Set the S3 to TX mode and connect it to your non-Bluetooth
audio transmitting device.
2. Place your Bluetooth audio receiving device, like earphones or
speakers, within a 3 feet / 1 meter range and set it to pairing
mode.
3. Turn on the S3 and tap the Power Button twice to enter pairing
mode. After approximately 10 seconds, pairing will be complete.
03 04