Overview Of The Components; Intended Use; Putting Into Operation - Clatronic KRC 788 Mode D'emploi

All manuals and user guides at all-guides.com

Overview of the Components

1 Display
2 Mounting Plate
3 Function button - alarm time (ALARM)
4 Function button - set time (TIME)
5 Throw-out aerial
6 Hours button (HOUR)
7 Battery compartment
8 Minutes button (MINUTE)
9 Station scale
10 TUNING control
11 VOLUME (-/+) control
12 Function selector switch (BUZZ/FM)
13 Function selector switch (ON/OFF/TIMER/ALARM)
14 LED display TIMER operation
15 Loudspeaker
16 LED display for activated alarm function (AL)

Intended Use

This is a kitchen radio for installation under a wall unit.
It is intended exclusively for this purpose and may only be
used as such.
It may only be used in the manner described in these
instructions for use. The device must not be used for
commercial purposes.
Any other use of this device is considered to be contrary
to the intended use and may result in damage to
materials or even personal injury.
The firm Clatronic International GmbH does not accept
any liability for damage caused as a result of the use of
this device contrary to its intended use.
Inserting the power reserve batteries
(not supplied)
If there is a power cut or the mains plug has been
removed from the power socket, the settings will be
retained if the power reserve batteries are inserted.
• Remove the mounting plate (2), by strongly pushing it
back to reveal the battery compartment (7).
• Insert 1 block battery of type 6 LR 61 6AM6. Ensure
the correct polarity. If the machine is not used for
a prolonged period, please remove the batteries in
order to avoid "leakage".
CAUTION:
Do not dispose of batteries in the domestic waste.
Please return used batteries to the relevant collection
points or the shop where they were bought.
26
WARNING:
Do not expose batteries to strong heat or direct sunlight.
Never throw batteries into fire. There is the danger of
explosion!
Assembly
Make sure that the plug is not inserted when assembling
the device.
NOTE:
• Remove all objects from the cupboard and anything
which is fragile in the adjacent cupboards.
• For the installation the cupboard must fulfil the
following conditions:
Thickness of the cupboard floor
between 16 and 20 mm
• The wall mounting of the cupboard must be stable
and anchored firmly in the wall with at least 2 screws.
• Important! Do not install the device above a
cooker!
• When installing the device it must be ensured that
there is a power socket within reach.
• The mains socket must be within easy reach, so that
the plug can be quickly removed in an emergency.
• Important! Do not connect the device to the mains
power supply until after installation!
• The device cannot be installed under cupboards
under which there is a lighting strip.
• This device can be attached using the screws supplied
to the underside of a wall cupboard, for example.
• First use the four screws to attach the mounting plate
(2) which is on top of the device and which is released
from the fixing device by pressing strongly towards the
rear.
CAUTION:
If other screws are to be used because the wall is
not thick enough, these screws may break through
the cabinet in certain circumstances!
• Now insert the radio into the assembly plate mounting
plate and press it to the rear until it locks in place.

Putting into Operation

1. Insert the plug into a properly installed 230 V, 50 Hz
power socket. Ensure that the voltage is the same as
that indicated on the model identification plate.
2. Push the ON/OFF/TIMER/ALARM switch (13) to ON.
3. Set the function switch BUZZ/FM (12) to FM.
4. Tune into the desired station using the TUNING
regulator (10).
5. If reception is too weak, try to improve it by changing
the position of the dipole antenna.