Pre-Operation Engine Inspection - Mitsubishi Heavy Industries GT Serie Mode D'emploi

PRE-OPERATION ENGINE INSPECTION

Be sure
to check the following before operating the engine.
1 Fuel inspection
• Is there gasoline in the tank?
• Is old gasoline being used?
• Add the correct fuel following the in-
structions on page 4 "FUEL AND
ENGINE OIL".
• Is the fuel tank cap closed correctly?
WARNING • Be sufficiently careful
of heat and flame when
handling and adding fuel. Not
doing so could cause a fire or
explosion.
2 Air cleaner inspection
• Is the air cleaner element dirty or is
the air cleaner oil (oil bath type)
insufficient?
• When the air cleaner element is dirty
or oil in the air cleaner is dirty or
insufficient, check and maintain
according to page 8 "CARE OF THE
ENGINE" and page 10 "INSPEC-
TION AND MAINTENANCE".
3 Engine oil inspection
• Is the engine filled with the specified
amount of engine oil? And is the oil dirty?
• If there is not enough oil, if it is dirty,
or it has been used longer than the
specified time, follow the inspection
and maintenance instructions on
page 4 "FUEL AND ENGINE OIL"
and page 8 "CARE OF THE
ENGINE".
All manuals and user guides at all-guides.com
• Standard fuel tank capacity and oil
― 5 ―
4 Inspect the tightness of
all fastener screws.
• Are all the screws tight?
• Be sure to check the screws used to
fasten the muffler. (Do this when the
muffler is cold.)
5 Component cleaning
inspection
• Are there grass, leaves, or combus-
tible materials around the muffler?
• Are there grass, leaves, or combus-
tible materials around the recoil
starter air intake?
If there is trash, etc., in the vicinity, be
sure to remove it before operating the
engine.
6 Fuel and oil leaks inspection
• Are there any fuel or oil leaks?
If any are found have the engine
repaired.
quantity for the various models
Model Fuel tank capacity
GT1000 6.0r
GT1300 6.0r
Engine oil quantity
1.0r
1.0r