Installing Printing Paper; Replacing The Ink Roller - Canon MP120-MG-es II Instructions

INSTALLING PRINTING PAPER

INSTALLING PRINTING PAPER
1) Lift up the paper arm (Figure
• When inserting the paper, cut the edge of the paper as shown.
2) Place the new paper roll on the arm. The edge of the paper should be positioned
as shown (Figure
• Standard paper roll – Width: 57mm / Diameter: 86mm max.
3) Insert the paper into the slit at the back of the machine as indicated. (Figure
4) Turn the calculator on. Press the key to advance the paper (Figure
REPLACING THE INK ROLLER (CP-13)
Note: Turn power switch off.
1) Remove the printer cover . (Figure
2) Hold the left side of the ink roller indicated as "pull up" and lift the ink rller up to
remove it. (Figure
• To maintain clear printing, change the ink roller after about 8 rolls of printing
paper have been used.
3) Insert the new ink roller into position. (Figure
4) Replace the printer cover. (Figure
• Use only the Ink Roller CP-13.
• Do not attempt to refill the ink roller, since this may cause mechanical
difficulties.
).
).
)
)
)
- 2 -
)
)
).