AudioLogic ALDV243 Manuel De Fonctionnement page 17

TROUBLE SHOOTING
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No Power
The power is on,
but DVD player
does not work
No Picture
No Sound
The playback
picture is poor
The DVD player
does not start
playback
The Remote
Control does not
work properly
ALDV243 Eng.indd 17
All manuals and user guides at all-guides.com
Cause
• The power cord is disconnected.
• No disc is inserted.
• The TV is not set to receive DVD
signal output.
• The video cable is not connected
securely.
• The connected TV power is turned off.
• The equipment connected with the
audio cable is not set to receive
DVD signal output.
• The audio cable is not connected
securely.
• The power of the equipment connected
with the audio cable is turned off.
• The Digital Audio Output is set to
the wrong position.
• The disc is dirty.
• No disc is inserted.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed with the
guide.
• The disc is dirty.
• A menu is on the TV screen.
• The remote control is not pointed
at the remote sensor of the DVD
player.
• The remote control is too far from
the DVD player.
• There is an obstacle in the path of the
remote control and the DVD player.
• The batteries in the remote control
are exhausted.
17
Correction
• Plug the power cord into the wall
outlet and unit securely.
• Insert a disc. (Check that the DVD or
audio CD indicator in the DVD display
is lit.)
• Select the appropriate video input mode on
the TV so the picture from the DVD player
appears on the TV screen.
• Connect the video cable into the
jacks securely.
• Turn on the TV.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD player.
• Connect the audio cable into the
jacks securely.
• Turn on the equipment connected with
the audio cable.
• Set the Digital audio Output to the correct
position, then turn on the DVD player
again by pressing the STANDBY button.
• Clean the disc.
• Insert a disc
• Insert a playable disc. (Check the disc
type, color system.)
• Place the disc with the playback side down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Press the SET UP button to turn off the
menu screen.
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control within
about 23ft (7m).
• Remove the obstacle.
• Replace the batteries with new ones.
2008/4/25 9:27:17 AM