Error Code; Set Operation - E-Bike E3000 Mode D'emploi Et D'entretien

Error codes are defined:

ERROR CODE

0 No fault
1 Current anomaly or MOS tube damage
2 Grip shifter anomaly (boot detection)
3 Motor phase failure
4 Abnormal motor Hall signal
5 Brake abnormal (boot detection)
6 Under voltage
7 Motor stop protection
8 Controller communication anomaly
9 Display communication anomaly
Only when the fault is excluded, the fault display interface can exit.
5.19

SET OPERATION:

Press the set key for 3 seconds to enter the set interface in the normal boot mode, and the set icon is in the
state of 1Hz flash.
Press the set button to switch from 0 to 4 cycle settings interfaces, long press the set key to exit the setup
interface.
In the current settings, press the key "+" or "-" to select the desired Parameter configuration. Long press
the SET key 1 second to save and exit.
5.20 DISTANCE INDICATOR.
Total distance (ODO): Total (Km) mileage recording from first riding to the current (Km) mileage, this
parameter in the conventional interface can be cleared by press "+" and "-" in 12s.
Trip distance: Single (Km) mileage, can be cleared by pressing "-" key in SET 1.( More than 500km
automatically cleared).
5.21 TRIP TIME INDICATOR: This parameter is automatically cleared after shutdown.
DEFINITION
82/89