Publicité
Les langues disponibles
Les langues disponibles
pool weight.
2. We recommend positioning the pool away from any objects children could use to climb into the pool.
3. Position the pool near an adequate drainage system to deal with overflow or to discharge the pool.
4. The surface must be flat and smooth. If the surface is inclined or uneven, it can create an unbalanced loading on the structure of
the pool. This situation can damage the welding point of the liner, the steel wall top and the vertical platforms. In the worst cases,
the pool can collapse, causing serious personal injury and/or damage to personal property.
5. The selected surface must be clear of any type of object. Due to the weight of the water, any object under the pool could damage or
perforate the bottom of the pool.
6. The selected surface must be clear of aggressive plants and weed species. Those types of strong vegetation could grow through
the liner and create water leakage. The grass or other vegetation that may cause odor or slime to develop have to be eliminated
from the set-up location.
7. The selected location must not have overhead power lines or trees. Be sure the location does not contain underground utility pipes,
lines or cables of any kind.
8. The selected position must be far from house entrance. Do not position any equipment or other furniture around the pool. The water
that comes out of the pool during the use or due to a faulty product can damage the furniture inside the house or surrounding the
pool.
9. The selected surface must be flat and without holes that can damage the material of the liner.
Follow the important instructions above to choose the correct surface and location to set up your pool. Damaged parts of the pool, due
to the fact that the set-up surface and location does not match the instructions, will not be considered as manufacture defect and will
avoid the warranty and any service claims.
Suggested set-up surfaces: grass, ground, concrete, and all other surfaces that respect the above set-up conditions.
Not suggested surfaces: mud, sand, gravel, deck, balcony, driveway, platform, soft/loose soil or other surface that does not meet the
above set-up conditions.
Check with your local city council for by-laws relating to fencing, barriers, lighting and safety requirements and ensure you comply with
all laws.
If have a filter pump, refer to the pump's manual for instructions.
The ladder must match the pool size and should be used only for entering and exiting the pool. It is forbidden to exceed the permitted
payload of the ladder. Check regularly if the ladder is properly assembled.
INSTALLATION
Installation usually takes approximately 2 hours with 2-3 people excluding earthworks and filling. Please refer to diagram steps.
Tools Required (not included):
NOTE:
Before connecting valve to the pool, fill the pool leaving 5 - 6cm of space between the position of the connection valve
and water surface.
WARNING:
Never permanently install the connection valve before the water is within a few centimeters of them because
the liner has to be properly taut from the pressure of the water.
NOTE:
Be careful the splinters or any sharp edges when cutting the pool.
IMPORTANT:
POOL MAINTENANCE
If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
Using chemical tablets (not included):
NOTE:
Chemconnect or Chemical Floater must be used when you perform chemical maintenance with tablets. Your
purchased item may not include any of those dispensers, in this case you can purchase it by visiting our website
www.bestwaycorp.com or at the nearest pool dealer.
Cutting more liner than necessary will damage and void the pool liner, so please trim with extra care.
4
Publicité
