Publicité
FINAL ASSEMBLY
5. Press the Shelf Hole Plugs [SS143] into the unused holes inside the cabinet. Place the Screw Head Caps [SS672] over any exposed
screw heads.
6. For D4 cabinets, insert clear Shelf Clips [211-1376] and [211-1377] into the holes in the back channel on the sides of the cabinet.
6B. Push the back of the shelf into both the left and right clips (A). Snap the shelf down into the clips (B).
7. For D6 cabinets, insert clear shelf clip [211-1305] into the holes in the back channel on the sides of the cabinet. Push shelf straight
into shelf clips.
5
8. Cabinet is supplied with magnet installed in accessory rail. If magnet needs to be repositioned horizontally, lightly pull on the magnet
while sliding side to side. If cabinet is installed as such to where magnet is upside down (on top of rail) as shown in Figure 8A, pull up
on magnet to unhook it from the rail. Reinstall by positioning as shown in Figure 8B, push and rotate magnet into accessory rail until the
back of the magnet is flush with the rail.
8A
9. Cabinet with electric are supplied with a wire management accessory, installed in the vertical track. To adjust position, rotate the
accessory 90 degrees as shown in Figure 9A, slide vertically as shown in Figure 9B to where needed, then rotate 90 degrees to lock it
in position. When in position, use the included wire strap to secure wrapped wires as shown in Figure 9C.
9A
90°
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
6
8B
9B
90°
6B
A
B
8C
2
1
13
7
9C
Part no. CB-209-1428 08/11/22
M Series Reserve Recess Cabinet
Publicité
Chapitres
