Safety Instructions; General Guidelines - Perel Tools CBAL2 Notice D'emploi

Introduction
1.
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.

Safety instructions

2.

General Guidelines

3.
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
•
Familiarise yourself with the functions of the device before actually using it.
•
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to the
device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
Features
4.
•
3 in 1: scale, clock and timer
•
scale with high-precision sensor
•
auto power-off (reverts to clock function)
•
timer (99m 59s) with memory function
•
wall-mounting (mounting accessories incl.)
•
foldable for space saving
•
4mm strong toughened glass platform
Use
5.
Refer to the illustrations on page 2 of this manual.
•
Before using the scale, remove the plastic tab from the battery compartment (see §6 Battery).
Mounting
•
The scale must be hung for best performance. Mount the mounting bracket [H] to a solid vertical surface
using the included screws. Make sure to leave at least 21cm free space above the mounting bracket so the
scale can be hooked over it easily.
•
Hook the scale over the mounting bracket [H].
Setting the clock
•
There are two ways to enter time setting mode:
o remove and re-insert the battery. The minutes-indication starts flashing.
o go to time-display by pressing the TIME button [C] until TM and the time are displayed [A]. Press and
hold the TIME button [C] until the minutes-indication starts flashing.
Note: the clock turns back to normal operation when no key press is detected within ±20s.
•
Press the UNIT button [B] to increase the value. Press and hold for faster adjustment.
•
Press the TIME button [C]; the hours-indication starts flashing.
•
Press the UNIT button [B] to increase the value. Press and hold for faster adjustment.
Note: the clock has a 12h format; AM or PM is indicated under the TM indication.
•
Press the TIME button [C] again or simply wait for ±20s to return to normal time display mode.
30/04/2009
All manuals and user guides at all-guides.com
User manual
Keep out of reach of children.
For indoor use only.
Keep this device away from rain, moisture, splashing and dripping liquids.
Protect the device against extreme heat and dust.
Protect this device from shocks and abuse.
Avoid brute force when operating the device.
CBAL2
3
©2008 Velleman Components nv
®