Drive PreserveTech RTL12C002-WH Mode D'emploi page 4

1. Remove existing toilet seat and lid assembly
2. Place rear support (I) on toilet bowl
and attach at required length based
on your toilet shape using fixing
screws (G) and knurled nuts (H).
NOTE: There are letter indicators on the
rear support (I) marked "E" for Elongated
and "S" for Standard to assist with which
hole to thread the fixing screws (G)
through for your toilet shape.
3. Insert adjustable holders (J) onto
the rear support (I) at the desired
seat height.
4. To set the height in the front, insert the
supports (K1) in the corresponding
opening until they click into place.
NOTE: Be sure that the supports (K1) are
inserted at the same height on the right
and left side. The supports (K1) can be
set lower than the rear support (I).
5. Insert supports (K2) in the corresponding
openings until they click into place.
assembly
J
H
G
I
6" / 15.2cm
4" / 10.1cm
2" / 5cm
I
I
H
G
J
J
6"/ 15.2cm
4"/ 10.1cm
2"/ 5cm
K1
K2