Publicité
Step 14 – Remote Control Programming (English)
ATTENTION!
EN
Must set WALL DETECT RIGHT first. Failure to do this may result in poor performance of Wall
Mount. If set LEFT WALL DETECT, please use the SETUP / RESET to clear memory.
STEP 1 = SETUP
Clears Memory & Set Home - Push &
Collapse the Mount Flat against the Wall at
EN
0 degrees, Press and Hold for 5 seconds to
set the home position (note: this also clears
all memorized commands)
STEP 3 = WALL LIMIT
LEFT SETUP
Swivel Left closest to the
Wall without the TV
EN
touching the Wall, leave
about 1" (25mm). Hold
down Wall Detect for 5
seconds till LED LIGHT
color turns solid.
EN
LEFT SWIVEL
STEP 4 = MEMORY 1
(optional):
Swivel / Tilt to Desire
EN
Position and Hold for 5
Seconds until LED LIGHT
color turns sold, memory
is set.
EN
TILT DOWN
!
CAUTION
ATTENTION!
Power Loss or interruption DOES NOT delete or clear the memory. User must use the SETUP /
EN
RESET button to clear memory. If Swivel too far RIGHT or LEFT and hits / makes contact with
the wall, the unit will Stop after 2 seconds.
LED LIGHT
Flashing LED: Transmitting Signal
EN
Solid Color LED: Memory Set or Cancelled
EN
TILT UP
STEP 2 = WALL LIMIT
RIGHT SETUP
Swivel Right closest to the
Wall without the TV
EN
touching the Wall, leave
about 1" (25mm). Hold
down Wall Detect for 5
seconds till LED LIGHT color
turns solid.
EN
RIGHT SWIVEL
STEP 5 = MEMORY 2
(optional):
Swivel / Tilt to Desire
EN
Position and Hold for 5
Seconds until LED LIGHT
color turns sold, memory
is set.
HOME
This will bring the wall
mount back to the wall of
HOME position that user
EN
setup, if user needs to set
a different Home position,
please refer to SETUP
button above for details.
P24
Publicité
