Sunforce 120 LED Mode D'emploi page 2

safety information
• Your motion light is not a toy. Keep it out of reach from small children.
• Your motion light and solar panel are both weather-resistant.
• You can mount your motion light indoors, but your solar panel must be installed outdoors to receive light
from the sun.
• If using a step ladder, you may require a second person to help install the solar motion light.
• Prior to installation, lay out all components and check against the part list section in this manual.
• Never look directly into the solar motion light when illuminated.
Battery replacement instructions
When replacing the batteries, be sure to:
• Use rechargeable batteries only.
• Match the replacement battery specifications with the batteries that have been removed.
• Observe the correct polarity (+ and -) when installing the replacement batteries.
• Replace the whole set of batteries at one time. Do not combine old and new batteries together
or those with different specifications.
care & maintenance
• From time to time, ensure the plug between the solar panel and light is securely connected.
• It is advisable to adjust the angle of the solar panel to optimize the exposure of the sun during the
winter months.
• The solar panel should be cleaned with a damp cotton cloth on a regular basis. This will ensure optimal
performance and battery charging. Periodically, utilize the same technique to clean the lenses of the
motion lights.
• Never let any abrasive material come into contact with the solar panel.
Warranty
This product is covered under a one year limited warranty. Sunforce Products Inc. warrants to the original
purchaser that this product is free from defects in materials and workmanship for the period of one year from
date of purchase. The included batteries are not covered under this warranty.
Proof of purchase including date, and explanation of complaint is required for warranty service.
product features
• 40 LEDs per lamp head • Adjustable time and distance settings
• Adjustable motion sensor • Solar panel with 4.5 m / 15 ft wire
2
4.4 cm / 1.7 in
installation
1
2
mounting BracKet template instructions
1. Cut out the template or use the provided insert.
2. Mark the screw hole locations ( X ) using a pencil or drill.
3. Drill holes in the marked locations.
Ensure your solar panel is placed so that its
1
exposure to the sun is optimized. Be aware of
objects such as trees or property overhangs
that may impede the panel's ability to
generate a charge.
Optional: Use a power drill (not included) to
create the holes on your chosen mounting
2
surface.
Use 4 of the included wall plugs and screws
to fasten the solar panel to the surface.
Place the mounting bracket template (refer
to template shown below or use provided
insert) over the desired mounting surface.
Mark the screw hole locations indicated by
the symbol.
3
Use a power drill (not included) to drill the
holes on your chosen mounting surface.
Insert the two remaining screws and wall
plugs into the surface, leaving 3.2 mm
(1/8 in) of space between the screw heads
4
and the wall. Place the motion light's
mounting bracket onto the screw heads (1).
Lock the bracket into place by shifting it
5
horizontally (2).