BS BATTERY BST 1000 Manuel D'instruction page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
Once the battery tester is well connected to the battery, the display will light on to indicate
tester version and battery voltage.
Tester will display the following contents after press any key.
• Battery test:
1. Battery Test
2. Cranking Test
3. Charging Test
4. Review Data
5. Print
• Select Battery Type
After the battery test selected, the battery tester will prompt to select battery type,
i.e. Regular Flooded, Lithium Ion ,AGM Flat Plate, AGM Spiral, Gel and EFB battery.
Press UP/DOWN key to select battery type, then press ENTER key to confirm.
Battery Type
1. Regular Flooded
2. Lithium Ion
3. AGM Flat Plate
4. AGM spiral
5. GEL
6. EFB
Battery System Standard and Rating: the battery
tester will test each battery according to the selected
system and rating.
Use UP/DOWN key to select according to the actual
system standard and rating marked on the battery.
See in the below picture, the arrow indicated location.
Select Input
CCA
It takes around 3 seconds to display the battery test result.
6
Voltmeter:
12.40V
Main Menu
Type
1. Car
2. Scooter
Setting Rate
500 CCA
BATTERY TEST RESULT
Battery test result includes 5 types as following:
Healthy >60%
Voltage >12.4V
Healthy >60%
Voltage <12.4V
Healthy <60%
Voltage >12.4V
Healthy <60%
Voltage <12.4V
Voltage <12.4V,
Healthy = 0
Electric Current = 0A or 0 CCA
1. GOOD BATTERY
Health: 96%
490CCA
Charge: 98%
12.64V
Internal R = 6.1mΩ
Rated: 500A
GOOD BATTERY
3. REPLACE
Health: 46%
490CCA
Charge: 8 0%
12.68V
Internal R = 18.1mΩ
Rated: 500A
REPLACE
5. CHARGE, RETEST
Health: 39%
310CCA
Charge: 20%
12.08V
Internal R = 30.1mΩ
Rated: 500A
CHARGE-RETEST
CRANKING TEST
Cranking test is the Engine ignition test. This test allows to check if the battery can provide
enough power to start the engine. It tests the battery instant voltage once start the engine.
If cranking voltage value is lower than 9.6V, the result is considered as abnormal.
If the result is higher than 9.6V, the result is considered as Normal.
Tester prompts as following:
Cranking Test
Cranking Test
Start Engine
RPM Detected
| www.bs-battery.com
Good battery
Good, Recharge
Replace
Charge, Retest
Bad cell , replace
2. GOOD, RECHARGE
Health: 78%
440CCA
Charge: 30%
12.20V
Internal R = 7.2mΩ
Rated: 500A
GOOD, RECHARGE
4. BAD CELL, REPLACE
Health: 0%
0CCA
Charge: 20%
10.64V
Internal R = 45.2mΩ
Rated: 500A
BAD CELL REPLACE
Cranking Test
Time
780ms
Cranking
Normal
10.13V
7

Publicité

Table des Matières
loading

Produits Connexes pour BS BATTERY BST 1000

Table des Matières