Charging The Battery; Inserting The Battery - Hilti NCR 060 II-A22 Mode D'emploi

Masquer les pouces Voir aussi pour NCR 060 II-A22:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Max. crimping / pressing force
Crimping / pressing time
Storage temperature
Ambient temperature for operation
4.1
Battery
Battery operating voltage
Ambient temperature
Storage temperature
Battery charging starting temperature
5
Operation
5.1
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
WARNING
Risk of injury by incorrectly positioned crimping jaws! Incorrectly positioned crimping jaws can fly out
like projectiles and cause injuries.
▶ Before and during the crimping operation, make sure that the crimping jaws are correctly positioned.
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
Observe the safety instructions and warnings in this documentation and on the product.
5.2

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 5
5.3

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
*2188462*
2188462
30 kN ... 60 kN
(6,700 lb
... 13,500 lb
)
f
f
≈ 5 s
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
21.6 V
−10 ℃ ... 60 ℃
(14 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
English
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ncr 060c-a22

Table des Matières