HoMedics mybaby soundspa portable Manuel D'instruction Et Information Sur La Garantie page 3

BATTERY PRECAUTIONS
• Use only the size and type of batteries specified.
• When installing batteries, observe proper +/- polarities. Incorrect installation of
batteries may cause damage to the unit.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
• Clean the battery contacts and also those of the device prior to battery installation.
• Remove batteries promptly after use.
• If the unit is not going to be used for a long period of time, remove batteries to
prevent damage due to possible battery leakage.
LISTENING TO SOUNDS
1. Power the unit on by pressing the Power button
2. Press the button of the sound you wish to listen to (Fig 1). The green POWER
LED will indicate the unit is on (Fig 1).
3. To adjust the volume, press the plus (+) button to increase the sound volume or
press the minus (-) button to reduce the sound volume.
4. When finished listening to sounds you may turn off by pressing the Power button.
Note: When the unit is turned on it will always default to the last sound used.
Using the Auto-Timer
1. When the power is on and you are listening to a nature sound you may set a
timer so the unit will automatically turn off.
2. Toggle through the TIMER button (Fig 1) until the corresponding LED illuminates
next to the time of your choice, 15, 30 or 60 minutes. The unit will automatically
shut off after the selected time and the POWER LED (Fig 1) will turn off as well.
Once the timer is set if you choose to listen a different sound, you may do so by
pressing the sound button of your choice (Fig 1). Or if you choose to listen to
the sounds continuously again, toggle through the TIMER button until the green
LED light is not illuminated on any of the time choices.
Note: Do not select the TIMER button if you wish to listen to the sounds continuously.
MAINTENANCE
To Store
You may leave the unit on display, or you can store it in its box or a cool, dry place.
Batteries should be removed prior to storage.
4
To Clean
Wipe off dust with a damp cloth. NEVER use liquids or abrasive cleaner to clean.
Modifications not authorized by the manufacturer may void users authority to
operate this device.
FCC DISCLAIMER
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void
the users authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
IC CAUTION
ICID: RSS-GEN ISSUE 4 DECEMBER 2014
This device complies with industry Canada License-exempt RSS standard(s).
Operation is subject to the following conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including that may
cause undesired operation of the device.
5