Parts & Assembly; How To Operate - Homecraft HCWKT1SS Manuel D'instructions

PARTS & ASSEMBLY
PARTS
Spout
Water Gauge
Kettle
Base

HOW TO OPERATE

Before using for the first time, it is recommended that you clean your 1L WATER KETTLE.
Simply boil a full kettle of water and then discard the water. Repeat process once more.
1. First, find a flat surface near an electrical outlet before starting.
Make sure your cord is away from any water source.
2. To fill kettle with water, remove kettle from the Base, push open Lid, and fill with desired
amount of water.
CAUTION: If water exceeds the MAX line (1liter) of water, the boiling
water may spill out during the boiling process. Do not fill less than
MIN line or run empty as it will shorten product life.
3. Push the Lid back down and position the kettle back on the Base.
Make sure the kettle is completely in contact with the Base.
4. Plug the power cord into an electrical outlet, then press the Switch to the ON position to
begin boiling water. The indicator light will illuminate blue.
NOTE: The kettle will switch off automatically once the water has boiled. You can shut off
power by moving the Switch to the OFF position at any moment during the boiling process.
5. When water is done boiling, pour the water from the Spout by lifting the kettle from the
Base using the Handle. Take care not to touch the body, as it will be hot.
CAUTION: Use caution when pouring boiling water from your
kettle, as boiling water may result in scalding.
5
Lid
Power Switch
Handle