Costway SUNDEAR MOON Manuel D'utilisation page 7

Warning
Tools Needed:
*Level
* Pencil *Hammer
*Screw Driver *Power Drill and drill bits
A wall mounting bracket is provide with the heater which has been
specifically designed to allow this product to be fitted to a wall or ceiling
before drilling the holders for the wall/ceiling is solid and that there are
no hidden water pipes or electric wires. The heater must be installed no
less than 16'' from side walls and no less than 6"' off the floor.
Important: Ensure that the supply cables is well mounted and that it
does not come into contact with reflector of the heater or that does not
trail into heated area, the supply cable can be fixed to the metal mounting
bracket behind heater with plastic zip ties.
1.This heater should be installed by a competent person, i.e. a qualified
electrician.
2.Always disconnected the heater from the electricity supply and allow it
to cool before installation.
3.This heater can be mounted in a horizontal or vertical manner.
4.For both wall and ceiling mounting, the lowest part of the heater must
be located at or above a minimum height of 1.8m from ground level, so
that the heater can not be touched when in operation.
5.When mounting horizontally or to a ceiling, do not position the heater
at an angle more than 90°and less than 45°as shown in Fig. A and B.
6.The supply cable must be at the lower end of the heater if the heater is
installed at an angle or vertically.
7.Keep the supply cord away from the body of the heater which will get
hot during use.
8.Do not install the heater on an inflammable surface.
07