IndoorCycling Group ANT+ CONSOLE Mode D'emploi page 9

BASIC SETTINGS
• Press "FLOW" button to start ANT+ RPM pairing.
(Put the console as close as possible to the transmitter and
provide RPM signal during the pairing process).
As soon as a RPM signal is displayed, pairing of
ANT+ RPM transmission is finished.
Proceed with basic settings process:
• Press "SUN" button to enter KM/MILE setting.
• Press "FLOW" button to select KM or MILES.
• Press "SUN" button to confirm your selection
and to enter gear ratio settings.
• Press "FLOW" button to select between
following gear ratios:
-1:3.1 for bikes with V-Belt Drive.
(IC3, S-/E-Series).
-1:1.0 for IC5 bike.
-1:4.3 for KRANKcycle.
• Press "SUN" button to confirm your selection
and finish the basic settings process.
09