Air Naturel SMARTAIR Notice D'utilisation page 9

OPERATING INSTRUCTIONS
- Put the air humidifier on a flat area
- Fill the water tank with cold tap water. Check that the cork is well closed
and that the seal is well put in the cork of the water tank
- Put the water tank back on the base of the device
- Plug the unit to the power source
Your air humidifier is now ready to be used!
- Press one time the button «power» to switch the device on. Another push
on that button will switch the device off.
- Press the button «max-min» to choose the speed of humidification. The
device has three different speeds of humidification.
- Press the button «ions» to activate the ionization mode. Press this button
another time in order to desactivate the ionization mode. This mode
increases the quality of the indoor air and engenders a feeling of well-
being. For more information on the ionization system, please visit our blog:
www.lebienairchezsoi.com.
- Before pressing the button «humi», the screen shows the current humidity
rate inside the room. You can adjust the desired humidity rate in the room
from 45% to 90%. Every time you press the button «humi», it increases the
desired humidity rate by 5%. When the desired humidity rate reaches 90%,
another pressure on the button will lead to a continuous humidification,
regardless the current humidity rate.
- Smartair is equiped with a timer mode which lasts between 1 and 12
hours. If you press the button «timer» one time, the device will automati-
cally stop after one hour of humidification; 2 pressures will stop the unit
after 2 hours; 3 pressures after 3 hours of diffusion...
- When there is not enough water in the water tank, Smartair stops working
by itself. Switch off the unit, refill the water tank and put it back on the
base of the device. The humidifier is now ready to be used again.
8