Battery Installation - Summer Baby Zoom Mode D'emploi

20021 Baby Zoom IB GB p3.pdf
SET UP & USE continued:
To Use the Video Monitor in Portable Mode continued:
• When battery is low, the Power On LED will illuminate amber, indicating that the battery needs to be recharged.
• To conserve battery power, use AC Adapter whenever possible. Remove battery during long periods of non-use.
• If battery is exhausted, remove immediately from the Monitor.
• Properly dispose of exhausted battery.

Battery Installation:

Note: This step is only needed if replacing battery.
1. Locate the battery compartment door on back of monitor.
2. Remove battery door screw with flat head screwdriver.
3. Remove battery door and battery.
4. Insert new battery and replace battery door.
Footrest:
The Monitor has a built-in footrest for tabletop convenience. Flip out footrest and place the Monitor
on a stable, level surface.
Pairing MONITOR and CAMERA:
The Monitor and Camera are paired at the factory for privacy reasons. If the Monitor and Camera are not pairing with each other for
any reason, please do so as described below.
Step 1: Move the Monitor to the same area as the Camera.With both the Camera and Monitor on, press the "POWER" button
once and using Camera/Menu control panel scroll to the Right and Up to "ADD CAM".Then press the OK/Zoom button.
Step 2: The Power LED flashes green and within 8 seconds, press the "CODE" button once at the side of the camera.
Step 3: The Power LED on the camera will flash and you should then see a picture from the Camera on the Monitor.
Step 4: If this is unsuccessful, you should repeat steps above making sure the Camera and Monitor are close enough to each other
for pairing and make sure the camera is off until the end of Step 2.
ADDING ADDITIONAL CAMERAS
To add an additional camera, follow the steps above for "Pairing Monitor and Camera". Use the VIEW CAM menu option to view one
specific camera, or SCAN to view each camera in turn.
This product can accept four cameras.To order an additional camera (our part number #28071U), please contact our Customer
Service Department by phone on +44 (0)208 420 4429 or customerserviceuk@summerinfant.com.
Note: The SCAN, DEL CAM,ADD CAM and VIEW CAM menu options are only used with additional cameras.
TIPS FOR IMPROVING RECEPTION:
• Position the Monitor closer to the CAMERA if necessary.
• Move Monitor away from other monitors, cordless phones, walkie-talkies, etc.; moving even slightly could greatly improve reception.
• If you hear a feedback or squealing noise, move the CAMERA and the Monitor further away from each other.
Note: Do not move the CAMERA head by hand as it may damage internal motor parts
1 06/01/2012 14:54
All manuals and user guides at all-guides.com