RealFlame 2609-O Manuel D'instruction page 4

Figure 2
6
1
Figure 4
All manuals and user guides at all-guides.com
8
5
Figure 3
Step Two
Figure 2
Insert the end of the Lift Assembly (8) into
the hole at the top of Lift Assembly Leg (9).
Using 2 bolts attach Lift Assembly to the left
side of the grate through two hole in the leg
on left side.
Step Three
Figure 3
Raise the handle on the lift assembly to the
open position.
Place the Front Log (5) and the Rear Log (6)
as shown in figure 3.
Step Four
Figure 4
Attach the Left Log (1) to the metal finger
stamped "1" with 2 bolts as shown in figure 4.
NOTE: Use caution not to over tighten bolts.