Useful Information, Precautions; First Installation; Instructions And Warranty - hajdu HB300 Manuel De Mise En Service, D'opération Et D'entretien

_________________________________ ___EN__________________________________20
 E--heater Mode: -30~43C,
In case of continuous hot water need under 100 L (60C).
Construction features
4.6.
HB300(C) heat pump water heater is basically composed of an upper part
(Figure 2.7.-1.) containing heat pump equipment and a lower part (Figure 2.7.-2.)
containing the storage tank. The storage tank of the sanitary hot water- having a
volume of – is covered by an enamel coating internally and by a thick polyurethane
insulation layer having large efficiency externally, and the latter is covered by plastic
surface of the appliance. The pipe radiator, controlling indicator anode electrics and
magnesium indicator anode located on the closing cover are placed on a horizontal
axle common with the closing cover.
The condensate water discharge pipe branch is located in the rear part of the
circle-shaped tray above. The control panel equipped with display is located in the
front part. All the other parts of the heat pump circuit are located above the storage
tank according to a precisely planned order, which produces optimal operation,
reduced vibration and noise emission.
The following parts are placed under an easily accessible and adequately
insulated plastic coverage: compressor, thermostatic expansion valve, evaporator,
fan ensuring adequate air flow and all the other parts displayed on Figure 2.7.-1.
5.

USEFUL INFORMATION, PRECAUTIONS

5.4.

First installation

WARNING
!
Putting into operation and first start up of the appliance can only be
performed by a technician according to all related effective regulations or legal
requirements or any requirements defined by local authorities and public
health organizations.
If the water heater to be installed does not simply replace an existing
appliance but it represents part of renovation of an existing hydraulic system
or a new hydraulic system, the company installing the water heater shall be
obliged to issue a compliance statement for the
buyer, certifying
specifications after finishing installation of the appliance. In both cases, the
company performing installation has to execute safety and operation checks
on the entire system.
Before starting up the hot water tank, please check that the installing
technician has performed all required operations of installation. Please ensure that
You have properly understood the information provided by the installing technician
on how to use the hot water tank and how to perform the operations on the
appliance.

Instructions and warranty

5.5.
The manual is an integrated and indispensable part of the appliance. Do not
remove the data label on the appliance for any reason as these data may be
required for any possible future reparations.
Please, read the warranty document related to the appliance carefully. This
document contains specifications regulating warranty.
All manuals and user guides at all-guides.com
compliance with all effective regulations and