Replacement Parts - Cannon 1904030 Manuel Du Propriétaire

Mounting Your Downrigger to the Pedestal Mount
The Cannon Pedestal Mount provides 1/4"-20 tapped mounting holes for attaching most downrigger mount-
ing bases. To attach a mounting base you will need four 1/4"-20 screws
screws needed, measure the thickness of the downrigger mounting base and add 1/2". See below for screw lengths
for the Cannon Downrigger mounting bases.
Magnum / Digi-Troll Tall Mounting Base —
Uni-Troll Low-profile Mounting Base — 1" Long Truss Head screw
Easi-Troll / Lake-Troll Tab-Lock Base — 3/4" Long Truss Head screw
Pedestal Mount \ Accessory Compatibility
Mounts
Track Mount
Pedestal
4" Fixed Mount
6" Fixed Mount
4" Sw ivel Mount
6" Sw ivel Mount
Troubleshooting - Swivel Pedestal
Problem: Pedestal will not rotate when the lock pin is disengaged.
Make sure the downrigger line is all the way up. Any load on the downrigger or pedestal may prevent the pin from
disengaging. Spray a lubricant into the slot which the lock pin slides. Make sure lock pin moves freely up / down.
Problem: Pedestal rotates while in locked position under normal use.
The break away bolts are not tight enough. Re-torque bolts to 25 ft-lb.
NOTE: Bolts may have to be tightened higher than 25 ft. lbs under some conditions. Do not exceed 35 ft-lb as this may
damage the top plate.
Problem: Pedestal did not breakaway while locked when the boom struck an object.
The break away bolts are over-tightened. Loosen bolts and re-torque to 25 ft. lbs.

Replacement Parts

Part
5
Gim bal Track Mount
● ○
● ○
● ○
● ○
●
- Compatible
Part Number Description
3393413 THUMB SCREW
(not included)
2" Long Truss Head screw
Pedestal Track Mount Rail Mount
○
○
○
○
○
- Not Compatible
USED ON
1904030, 1904031, 1904032, 1904033
. To determine the length of
Clam p Mount
○ ○
○ ○
○ ○
○ ○
Deck Mount
●
●
●
●