Cannon 1904030 Manuel Du Propriétaire page 4

Mounting the Pedestal to Your Boat
Mounting Directly to Deck or Gunnel
Carefully choose an ideal position where you may best utilize your pedestal mount. Use the base of the pedes-
tal as a template to mark hole locations and drill four 9/32" diameter through holes. Fix the pedestal to the deck or
gunnel using four 1/4"-20 flat head screws with four flat washers, lock washers, and nuts
mine the length of screw needed, measure the thickness of deck that you are mounting to and add at least 3/4".
Mounting to Cannon Track Mount
For versatility and lightening quick mounting, the Cannon Mounting Track
system is ideal for utilizing your pedestal mount on your boat. Slide the base
of the pedestal into the track and tighten the thumb screws to fix the pedestal in
position. You may use a 3/16" Allen wrench for additional tightening.
Note: For the Swivel Pedestal Mount, rotate the release handle to access the top of
the thumb screw with the Allen wrench.
1904025 Aluminum Mounting Track 6"
1904026 Aluminum Mounting Track 12"
1904027 Aluminum Mounting Track 18"
1904028 Aluminum Mounting Track 24"
1904029 Aluminum Mounting Track 36"
Cannon tracks allow for flexible mounting positions and easy
removal of Cannon's track system accessories. Locking grooves allow
thumb screws to index with track and prevent accessories from twist-
ing. The system is compatible with Cannon, Bert's, and Traxtech track
system products. Components are made from clear anodized aluminum
and stainless steel for strength and corrosion resistance. All mounting
hardware included. Available in 6, 12, 18, 24, and 36 inch lengths.
Mounting to Cannon Deck Mount
The Cannon Deck Mount works great for adding stability and easy removal of your pedestal mount. With your
Cannon Deck Mount installed on your boat, attach your pedestal mount by removing the thumb screws and fasten-
ing the pedestal base to the plate with four 1/4"-20 x 3/8" long flat head screws.
1904000 Deck Mount
The Cannon Deck Mount plate is a four inch by three inch
clear anodized aluminum plate which allows the hard mounting
of Cannon Dual Axis Rod Holders. The plate comes with a black
protective mounting boot and all mounting hardware.
4
. To deter-
(not included)
CAUTION:
The Cannon Pedestal
Mount is intended for
use with a Track that is
mounted directly to the
deck of the boat ONLY.