Thermal Overload Protector; Limit Switch; Control Buttons - Hamilton Beach Commercial HVS400 Mode D'emploi

THERMAL OVERLOAD PROTECTOR

The Vacuum Sealer will automatically shut down if it overheats. If this occurs,
turn the unit "OFF" ( ) and open the Vacuum Lid. Resume normal operation
after the unit cools for about 20 minutes.
To help prevent overheating, wait at least 20 seconds between cycles with
the Vacuum Lid open. Avoid touching the Seal Bar Tape. The Seal Bar Tape
will remain hot for a brief period of time after each sealing cycle.

LIMIT SWITCH

The Vacuum Sealer is equipped with a switch to prevent actuation of the Seal
Bar Heating Element in manual mode when the Vacuum Lid is open. When
the Vacuum Lid is closed, heat made by the Seal Bar Heating Element is
absorbed by the vacuum bag and Vacuum Lid Seal.
When the Vacuum Lid is open, there is no means to dissipate the heat and
unit damage may occur.

CONTROL BUTTONS

STOP BUTTON
Press the "STOP" Button to halt the vacuuming process (FIGURE 2).
MANUAL SEAL BUTTON
Press the "MANUAL SEAL" Button during the vacuuming process to initiate
the seal (before the preset vacuum pressure is reached) (FIGURE 2).
START BUTTON
Press the "START" Button to initiate the vacuuming process (the Vacuum
Sealer will automatically seal the bag when a preset vacuum pressure is
reached) (FIGURE 2).
FIGURE 2
7