Silverline 834832 Traduction Des Instructions Originales page 12

GB
Troubleshooting
Problem
No detergent suction
Smoke
Pressure washer doesn't start
Poor water spray pressure
Motor stops suddenly
Water leaking from pump
12
Possible cause
Blockage in detergent bottle tube
Overload or damaged motor
Pressurised
Mains plug not fully inserted or mains socket is switched
OFF
RCD has operated or not been reset
Plug fuse has blown
Thermal safety switch has operated
Water inlet filter is clogged
Water hose connection is leaking or allowing air to enter
Pressure washer valves or seals are worn or damaged
Clogged nozzle
Thermal safety switch has operated
Seals worn out
Solution
Clean with warm water
DO NOT USE. Contact dealer or authorised Silverline service centre immediately
Squeeze trigger on gun before starting
Check and correct issues
Reset RCD
Replace fuse and contact dealer if it blows again immediately
Switch OFF and allow pressure washer motor to cool before starting
Clean filter
Check water hose connection
Contact dealer or authorised Silverline service centre immediately
See 'Maintenance' for cleaning procedure
Switch OFF and allow to cool before restarting
Contact dealer or authorised Silverline service centre immediately