Whirlpool AWZ9CD/PRO Consignes D'installation, D'utilisation Et De Sécurité page 128

TROUBLESHOOTING
GUIDE & AFTER-SALES
SERVICE
Your dryer is equipped with various automatic
safety functions . These enable failures to be
detected in good time and the safety system can
react appropriately . These failures are frequently
so minor that they can be removed within a few
minutes .
Problem
DRYING TAKES TOO LONG
LAUNDRY IS NOT DRY
ENOUGH
DRYER DOES NOT START,
ALTHOUGH START/PAUSE HAS
BEEN PRESSED
128
All manuals and user guides at all-guides.com
Possible Cause
Selected programme not
optimum for type of laundry
Door filter or bottom filter
clogged
Laundry too wet
The ambient temperature is too
high
Door not properly closed
Key lock is activated
Solution
• Select the programme
matching best the type of
laundry; refer to section
PROGRAMMES
• Clean the filters according to
the instructions in section CARE
AND MAINTENANCE
• Make sure that laundry is spun
with the maximum spin speed
before drying . If laundry was
spun with spin speed below 800
rpm, the water tank may get full
during the drying programme .
• The ambient temperature
is ideal between 15 and 20°C .
If the ambient temperature is
higher, air the room .
• Push door to close it until it
clicks shut
• Press and hold the button
with the key symbol until the
display indicates that the keys
are unlocked .