Binzel CAT3 Mode D'emploi page 40

11 Disassembly
11 Disassembly
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing,
assembly, disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Close the gas supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
NOTICE
• Disassembly may only be carried out by qualified personnel
(in Germany see TRBS 1203).
• Please also consult the operating instructions for the welding components, such as the
power source and compressed air line.
• Observe the information provided in the following chapter:
 8 Putting out of operation on page EN-17.
 Fig. 7 Attaching the CAT3 to the robot on page EN-14
1 Remove the parts to be disconnected.
EN - 20
CAT3
BAL.0324.0 • 2018-06-13