Attachment To Bicycle; Front Wheel And Handle Installation - Klarfit Husky Vario Mode D'emploi

EN
18

ATTACHMENT TO BICYCLE

The drawbar can be easily and quickly connected to the bicycle: Unscrew the
rear hub nut and insert the hook between the bicycle frame and the rear hub
(like an additional washer).
Screw the rear wheel of your bike back in place.
As shown in the picture, the hook should be mounted
with the „male" part pointing backwards and away from
the bicycle. Place the hanger behind the bicycle and
integrate the „male" part into the eyelet provided for this
purpose („female" part, see illustration).
Secure the connection to the seat belt by wrapping it once around the bicycle
frame (make sure it does not get into the spokes) and attaching it to the hanger
part of the pull rod.

FRONT WHEEL AND HANDLE INSTALLATION

Installing the front wheel
• Make sure that the trailer hitch is
engaged under the frame.
• Fasten the front wheel assembly:
Slide the short square tube on the
front wheel over the matching tube
on the lower edge of the front edge
of the trailer cab. Align the holes in
each tube, insert and tighten the
quick-release pin.