Applications; Conformity And Approval; Setting The System Into Operation; Setting Up The Transmitter - Monacor International JTS SIEM-2 /5 Mode D'emploi

2 if a defect might have occurred after a unit
was dropped or suffered a similar accident,
3 if malfunctions occur
In any case the units must be repaired by skilled
personnel
•
For cleaning only use a dry, soft cloth; never use
water or chemicals
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
are not correctly connected or operated, or if
they are not repaired in an expert way
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful
to the environment
3

Applications

The set SIEM-2 / 5 is a wireless mono audio trans-
mission system designed for stage monitoring
(in-ear monitoring); it is also suited for various other
mobile audio signal transmissions, e g wireless
command or control transmission The set includes
the transmitter SIEM-2T and the receiver SIEM-2 / R5
with the earphones IE-1 To extend the system,
the receiver and the earphones are also available
separately Thus, you will be able to operate any
number of receivers with a single transmitter

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the units SIEM-2 / 5 and SIEM-2 / R5 comply with
the directive 2014 / 53 / EU The EU declarations of
conformity are available on the Internet:
www jts-europe com
The transmitter SIEM-2T may be operated in the
following countries:
DE
In the Federal Republic of Germany, the transmitter
SIEM-2T requires a frequency assignment (for
which a charge is payable)
In other countries, it is necessary to apply for a cor-
responding approval Prior to operating the system
outside Germany, please contact the MONACOR
subsidiary or the corresponding authorities of the
respective country Links to the national authorities
can be found via the following Internet address:
All manuals and user guides at all-guides.com
www cept org
t ECC
t Topics / Info
t SRD* Regulations and indicative list of equip-
ment sub-classes
t Tools and Services
t EFIS – ECO Frequency Information System
t National Frequency Tables
*Short Range Devices
4

4.1 Setting up the transmitter

To obtain the best transmission quality, place the
transmitter at the height of the receiver (approx
1 m above the ground) Make sure that there are no
obstacles between the transmitter and the receiver
Keep a distance of approx 1 m between the trans-
mitter and lateral walls
(482 mm / 19"), use the mounting frame DR-900SET
The frame allows installation of two transmitters
tenna (7) in a vertical position

4.2 Connecting the transmitter

1) Connect the signal source(s), e g microphone,
output of a mixer, to the jacks MIC / LINE (1) The
jacks are designed for balanced signals If there
is only an unbalanced signal at the output of
the signal source, feed this signal to the input
jack via a 6 3 mm mono plug
2) To route the input signals from the jacks MIC /
LINE 1 and 2 to another unit (e g amplifier,
second transmitter, recorder), these signals are
available at the jacks LOOP OUT (8)
3) For power supply, connect the power supply
unit provided to the jack "⎓DC 12~18V" (11),
then connect it to a mains socket (230 V/ 50 Hz)
plug from the jack "⎓DC 12~18V", wrap the
cable around the hook (9) from below for strain
relief
Setting the System
into Operation
For installing the transmitter into a rack
After setting up, place the transmitting an-
To prevent accidental disconnection of the
9