Charging The Rechargeable Battery; Before Using The Device For The First Time; In Daily Use - Meister AS108VM Traduction Du Manuel D'utilisation Original

5401030-Akku-Bohrs-man 18.02.14 09:30 Seite 49
Power consumption
Output voltage
Capacity
Protection class
Protection class
5 – Charging the
rechargeable battery
Before using the device for the first
time
The battery is not completely
charged when the item
leaves the factory.
Figure 5-1: Connect the plug power
supply and the charger cradle. Insert the
rechargeable battery as far as it will go
into the battery compartment.
The LEDs on the battery indicate the
charging process:
LED LED LED
Red Yellow Green
The charging process takes about
3 to 5 hours.
Remove the rechargeable battery from
the charger cradle after you have
finished charging it.
The rechargeable battery will
attain its full performance
All manuals and user guides at all-guides.com
12 W capability only after a number of
12 V – ...
charging cycles.
400 mA
II (dual Figure 5-3: Insert the rechargeable
insulation) battery as far as it will go into the
IP X0 handle of the cordless drill-screwdriver.
The cordless drill-screwdriver is ready
for operation.

In daily use

Figure 5-2: Check the battery charge
state:
LED
Red
Charging
process
Figure 5-4: Take the rechargeable
battery out of the handle of the cordless
Initial
drill-screwdriver.
Advanced
Figure 5-1: Charge the rechargeable
Complete battery.
Figure 5-3: When the rechargeable
battery has been charged, insert as far
as it will go into the handle of the
cordless drill-screwdriver.
The cordless drill-screwdriver is ready
for operation.
In order to protect the
rechargeable battery:
Recharge the battery before
it is completely discharged.
LED LED Charge state
Yellow Green
Almost empty
Half-full
Full
49